Fill and Base Material Delivered in St. Paris, OH

For gravel and aggregate delivery in St. Paris, OH, start with the ground you are building on. This part of Champaign County sits on glacial till: clay loam and silty clay over gently rolling ground, with flat wet swales between low moraine ridges. Ohio Rock Supply delivers 304 limestone, fill dirt and the rest of the base and drainage materials by the ton.

Clay that drains slowly is why an under-built base fails here. The base depth you choose matters more than the surface stone you put on top of it.

Delivery to St. Paris and the Surrounding Area

You order online, choose a quantity by the ton or yard, and pick your delivery date at checkout. If you are unsure how much material the job needs, size the load with the calculator before you check out. A dump truck then delivers to your site in St. Paris or the surrounding area.

Ohio Rock Supply delivers across Champaign County, including Urbana, Mechanicsburg, North Lewisburg, Woodstock and Cable. If your site is a building pad on the edge of town or a driveway out in the flats, the truck comes to you.

Materials for St. Paris Projects

Most jobs here start with grade, not with surface. Raising a low spot or building up a pad means bulk fill first, then a compacted base, then whatever finishes the surface. Working in that order saves you from redoing a drive or patio later.

For raising grade and building pads, Fill Dirt is the bulk material that brings a site up to level before any base goes down. On top of that goes 304 Aggregate Base. It is what you compact under a driveway, parking pad or shed, and under the asphalt itself.

Once the 304 limestone is compacted, 411 Stone tops a gravel drive or beds a paver patio. It packs tight over the base because it carries fines.

For drainage and finishing work, clayey till makes water the other half of the job:

• #57 Limestone for French drains, drive surfacing and concrete aggregate.
• #8 Crushed Stone for pipe bedding, paver joints and fine drainage.
• Screenings for paver and patio bedding and firm path surfaces.

Sand and soil round out a full build. Mason Sand handles brick and block work and paver joints, and Top Soil dresses the lawn once the ground work is done.

Ground and Conditions in St. Paris

Glacial till drains slowly, so water ponds in flat swales and low spots after spring rain and snowmelt until ditches or tile clear it. Valley sand and gravel drain quickly by comparison. That difference decides where a base needs a drainage layer and where it does not.

Erosion follows the same water. Stream and ditch banks scour after heavy rain, bare graded soil washes, and steep valley sides slump. Armor those spots with RipRap or a dry creek bed of Large River Rock before the next storm season.

Timing matters as much as material. Base, driveway and paver work starts once the ground thaws and the flats dry out in spring, then runs into late fall. Frozen or saturated clay will not compact well, so a spring pour over wet ground is money wasted.

Cold winters bring repeated freeze-thaw, which heaves wet clay under drives and patios and lifts shallow posts and pads. Frost depth is 32 inches in Columbus and Dayton, set by each local building department. Deck and post footings are sized to that depth; drives are not.

Order Base and Fill Material for Your St. Paris Job

304 limestone is the material most St. Paris jobs are built on, with fill dirt underneath it and clean stone or 411 limestone finishing the surface. Decide what the ground needs, size your load with the calculator, and place your order online for delivery to your site.