Crushed Stone, Sand and Gravel in St. Marys, OH

Ohio Rock Supply handles gravel and aggregate delivery in St. Marys, OH for two kinds of buyers: contractors who order by the load and homeowners fixing one drive or one bed. Both usually start with 304 limestone, the base stone this market specifies, and both run into the same clay till ground.

The difference is scale. A builder grading a pad needs fill and base in volume, while a homeowner wants a few yards of topsoil or a clean stone for drainage. The material choices are the same either way.

Materials for St. Marys Projects

Grading and bed prep drive most orders here, so soil and fill lead the list. Glacial till clay sits under a thin top layer across much of Auglaize County, and that subsoil will not grow a lawn or hold a bed on its own. A screened Top Soil layer gives roots something to work in, and Garden Soil is the better pick for raised beds and planting areas where you want a looser mix.

Before any of that goes down, low spots need to come up. Fill Dirt handles grading, leveling and backfill, and it is the right first step on a wet flat that will not drain. Bring the grade up with fill, then cap it with topsoil.

Under drives, pads and shed floors, the base course matters more than the surface. 304 Aggregate Base is the standard Ohio base stone. It compacts tight and carries the load above it. Where you want a packed gravel surface rather than a buried base, 411 Stone tops a compacted 304 layer and beds pavers.

Drainage and finish work pull from the clean stone and sand families. #57 Limestone is the size Ohio suppliers stock most widely, and it suits French drains and drive surfacing. Screenings set pavers and firm up paths, while Washed Sand beds and levels under slabs.

Ground and Conditions in St. Marys

Water is the thing to plan around. Clayey till drains slowly, so after spring rain and snowmelt, water sits in the flat swales and low spots until ditches, tile or dry weather clear it. Valley sand and gravel drain fast, but the flats do not.

That shapes material choice. A drive or pad built straight onto saturated clay will not compact well, so the ground has to dry or the grade has to come up first. Fill and a properly compacted 304 limestone base do that work. Where water still collects, a clean stone drainage layer moves it instead of holding it.

Cold winters bring repeated freeze-thaw. That heaves wet clay under drives and patios and lifts shallow posts and pads. Frost depth runs 32 inches in Columbus and Dayton, set by each local building department, so footings and post depths follow the local official rather than a rule of thumb.

Timing matters too. Base, driveway and paver work starts once the ground thaws and the flats dry out in spring and runs into late fall. Frozen or saturated clay will not compact, and laying base into it wastes the load.

Erosion shows up on stream and ditch banks after heavy rain, on bare graded soil, and on steep river valley sides that slump. RipRap and large river rock armor those edges, and seeding bare ground early limits the wash.

Delivery to St. Marys and the Surrounding Area

Bulk material arrives by dump truck and is tipped at the site. Have the drop spot clear, reachable, and on firm ground, because a loaded truck needs room to turn and a surface that will not sink. Point out overhead lines, septic lids and anything buried before the truck backs in.

Ordering runs online. You pick the material, choose a quantity by the ton or by the yard, and set a delivery date at checkout. If you are unsure how much you need, the calculator sizes the load for you.

St. Marys sits in Auglaize County, and delivery covers the county, including Wapakoneta, Minster, New Bremen, New Knoxville and Waynesfield.

Questions About Ordering in St. Marys

Can I order material by the ton for delivery in St. Marys?

Yes. You choose a quantity by the ton or by the yard when you order online, then pick a delivery date at checkout. Bulk loads arrive by dump truck and are tipped at your site. If you are not sure how much the job needs, the calculator sizes the load from your project details, so you order once and get the amount you actually need.

What stone should I use for drainage in St. Marys?

Clean stone, not a base material. #57 limestone is the usual choice for French drains and downspout runs, and #8 crushed stone works for finer drainage and pipe bedding. #4 crushed stone suits heavy drainage and trench bottoms. Base stone like 304 limestone packs tight and holds water, so keep it under the drive and let clean stone move the water away.

Order Grading and Drainage Material in St. Marys

Ohio Rock Supply delivers base stone, fill, topsoil, sand and clean stone to St. Marys for driveways, parking pads, shed bases, paver work, lawn prep and drainage. Pick your material, size the load with the calculator, and choose a delivery date at checkout to place your order.