Bulk Material Delivery in Irwin, OH

Ohio Rock Supply handles gravel and aggregate delivery in Irwin, OH, and the first job is sizing the load. Run your numbers through the calculator before you order, then pick the material. For most work around here that means 304 limestone.

Irwin sits in Union County, on glacial till ground that drains slowly in the flats and sheds water fast in the valleys. That split drives what you put down.

Materials for Irwin Projects

Slope, swale and bank protection is the work this ground asks for. Clay loam till sheds water slowly until it does not, and then the ditches and stream banks move. Coarse, angular stone is what holds them.

We run it from coarsest to finest, so you can match the size to the job.

Start with RipRap where a bank is cutting away. Set it over a filter layer of #4 Crushed Stone so the fine ground does not wash out from under the rock.

For a French drain or a downspout run, #57 Limestone is the clean stone Ohio yards stock most widely. It has no fines, so water moves through it instead of sitting.

Where you want a slightly smaller clean stone, #67 Stone works the same way. Use #8 Crushed Stone for pipe bedding and tight spots.

Under all of it, 304 Aggregate Base is the standard base stone. It packs tight because the fines bind, which is why it goes under asphalt and under every driveway in the county.

Delivery to Irwin and the Surrounding Area

Order online and choose your quantity by the ton or the yard. If you are not sure how much the job takes, the calculator sizes it for you before checkout.

Pick your delivery date at checkout and a dump truck brings the load to your site in Irwin. Have the drop spot clear and reachable, and tell us where you want it placed.

We deliver across Union County, including Marysville, Richwood, Milford Center, Plain City and Raymond. Bulk loads go to driveways, job sites, farm lanes and field entrances.

Ground and Conditions in Irwin

Timing matters more than anything else here. This is glacial till, clay loam to silty clay over gently rolling ground, with low moraine ridges and flat wet swales between them.

That clayey till drains slowly. Water ponds in the flat swales and low spots after spring rain and snowmelt until ditches, tile or dry weather clears it. Valley sand and gravel, by contrast, drains quickly.

So base, driveway and paver work starts once the ground thaws and the flats dry out in spring, and runs into late fall. Frozen or saturated clay will not compact well, and a base that never compacted will not hold.

Cold winters also bring repeated freeze-thaw. That heaves wet clay under drives and patios and lifts shallow posts and pads. Frost depth runs 32 inches in Columbus and Dayton, set by each local building department, so check with yours on footings and pads.

Erosion is the other half. Heavy rain scours stream and ditch banks, washes bare graded soil, and slumps the steeper valley sides. Armor those banks before the next storm, not after.

Questions from Irwin Buyers

What stone should I use for drainage in Irwin?

Use clean stone, not base. #57 limestone is the standard for French drains, downspout runs and foundation drains, with #67 or #8 for tighter spots and pipe bedding. For heavy drainage, trench bottoms and inlets, step up to #4 crushed stone. Line the trench with filter fabric so the clay till does not migrate in and clog the stone.

What should I have ready when the truck arrives?

A clear, firm route for the truck and a marked drop spot. Point out overhead wires and any soft ground before the bed rises. If you want the load tailgated along a drive instead of dumped in one pile, say so up front. Keep people and pets clear while the bed is up.

Order Bulk Stone for Your Irwin Project

Ohio Rock Supply delivers bulk gravel, stone, sand and soil across Irwin and Union County, from Marysville to Plain City and Raymond. Size your load with the calculator, pick your material and your delivery date, and place the order online. We will get the truck out to your site.