Skip to main content
FREE Delivery!|(216) 247-5333
Jefferson County, OH Gravel and Landscape Rock Delivery

Jefferson County, OH Gravel and Landscape Rock Delivery

Ohio Rock Supply handles gravel, stone and aggregate delivery in Jefferson County, OH. Start with the calculator to size your load, then pick the material. Most jobs here begin with 304 limestone. It goes under drives, pads and pavement. The hills here are mostly unglaciated, with clayey slope debris on the hillsides and sand and gravel in the river bottoms.

Delivery across Jefferson County

Order online and choose the quantity you need by the ton or the yard. The calculator helps you size the load before you check out, so you are not guessing at a number.

At checkout you pick a delivery date that works for your schedule. A dump truck then brings the material to your site and drops it where you want it. That covers Steubenville, Toronto, Mingo Junction, Tiltonsville, Brilliant, Dillonvale, Richmond, Bergholz, Yorkville, Adena, Rayland, Amsterdam, Irondale and Bloomingdale.

Bulk delivery suits drive builds, drainage runs, paver patios and grading jobs. If you are working a steep lot, tell us where the truck should drop so the pile stays usable.

Materials delivered in Jefferson County

Stone is sold here by number, the way Ohio suppliers do it. Sizes run from coarse base stone down to fine bedding material. Here is what each one is good for.

304 limestone carries the most weight on local jobs. It is a mix of stone and fines that compacts into a hard, stable base. Contractors here order it for driveways, parking pads, shed bases and the course under asphalt.

411 limestone is the topping. It runs up to about 1 inch with fines, so it packs tight over a 304 base. Use it on gravel drives and parking areas, or as bedding under pavers. For clean stone, #57 limestone is the size Ohio suppliers stock most widely, and #8 and #4 cover finer and heavier drainage work. Screenings and topsoil round out most orders.

Ground conditions across Jefferson County

This is hill country. Soils are thin to moderately deep, weathered from sandstone, shale and coal-bearing rock, with clayey slope debris on the hillsides. The flat river bottoms hold sand, gravel and silt instead.

Steep slopes shed heavy rain fast into narrow valleys. That runoff scours ditches and culverts, and the low bottoms flood. Water seeping from hillsides also softens cuts and fills, which is where a clean drainage layer earns its place.

Landslides and slumps happen on steep hillsides of clayey slope debris and soft red shale after heavy or prolonged rain. Stream bank scour follows in the narrow valleys. RipRap on banks and culvert outlets helps hold those edges.

Long wet spells saturate hillsides and set off slips. Cutting, filling and driveway work on slopes goes best in drier weather, so the working season runs from spring into late fall. Winters bring repeated freeze-thaw, which pries weathered rock apart and heaves wet clayey soil on cut slopes and on drives built into hillsides. Frost depth is set by each local building department, so confirm the local figure before digging footings or posts.

Choosing the right material

Belmont and Carroll counties share this ground zone, mostly unglaciated hills with thin to moderately deep soils and clayey slope debris. The same base and drainage choices carry over. Typical projects there look like the ones here: drive builds, drainage runs and slope work.

Columbiana County spans more than one zone. Part of it sits in the glaciated plateau of northeast and east-central Ohio, and part in this same hill country. On the glaciated side, ground is often less steep, so a straightforward 304 limestone base and a standard drainage layer may cover the job. On the hill side, plan for slope runoff the way you would here.

Match the material to the job. Use 304 limestone under anything paved or parked on. Top it with 411 limestone on a gravel drive. Reach for #57 limestone or #4 crushed stone where water has to move, and screenings where you need a firm, fine surface under pavers.

Order gravel and stone for Jefferson County

Ohio Rock Supply delivers bulk gravel, stone, sand, topsoil and mulch across Jefferson County, from Steubenville and Toronto to Dillonvale, Adena and Bloomingdale. Size your load with the calculator, choose your material, and pick a delivery date at checkout. A dump truck brings it to your site. Place your order online when you are ready.

Towns we deliver to in Jefferson County

Frequently Asked Questions

Common questions about gravel and aggregate delivery in Jefferson County

What is the best base material for a patio in Jefferson County?

304 limestone is the standard base here. It compacts into a hard, stable course under pavers and slabs. On the clayey hillside soils common in this county, a well-compacted 304 layer matters. Top it with screenings for bedding, or with 411 limestone if the patio edge meets a gravel drive.

Can I order material for a commercial or contractor job?

Yes. Order online the same way on a contractor or commercial job. Size the load by the ton or the yard with the calculator, then pick your delivery date at checkout. A dump truck delivers to the site. Bulk orders for drive builds, drainage runs and grading work are handled the same way as any other order.

When is the best time of year to order base material in Jefferson County?

Spring into late fall is the working season. Long wet spells saturate hillsides and set off slips, so cutting, filling and driveway work on slopes goes best in drier weather. Order when the ground is workable and you can compact the base properly. Winter freeze-thaw heaves wet clayey soil on cut slopes and on drives built into hillsides.